Thus, where a parameter setting is accessible from both the CLI and the menu interface, if you change the setting in the CLI, the new value will appear in the menu interface display for that parameter. Also, the menu interface displays the current running-config values. Using the S ave command in the menu interface does not save a change made to the running config by the CLI unless you have also made a configuration change in the menu interface. That is, if you use the CLI to change a parameter setting, but then reboot the switch from either the CLI or the menu interface without first executing the write memory command in the CLI, the current startup-config file will replace the running-config file, and any changes in the running-config file will be lost. NOTE: If you use the CLI to make a change to the running-config file, you should either use the write memory command or select the save option allowed during a reboot (see Boot prompt for an unsaved configuration) to save the change to the startup-config file.
If you subsequently reboot the switch, the auto-10 mode configuration on port A5 will remain because it is included in the startup-config file. The new mode ( auto-10) on port A5 is now saved in the startup-config file, and the startup-config and running-config files are identical. HP Switch(config)# interface e a5 speed-duplex auto-10Īfter you are satisfied that the link is operating properly, you can save the change to the switch’s permanent configuration (the startup-config file) by executing the following command: The following command configures port A5 to auto-10 mode in the running-config file, allowing you to observe performance on the link without making the mode change permanent. Because 100 Mbps over Cat 3 wiring can introduce transmission problems, the recommended port mode is auto-10, which allows the port to negotiate full- or half-duplex, but restricts speed to 10 Mbps. Suppose that your network uses Cat 3 wiring and you want to connect the switch to another autosensing device capable of 100 Mbps operation. These config changes may be incompatible or not used after a reboot or failover."įor example, the default port mode setting is auto.
#HP 2810 48G SHOW MAC ADDRESS SOFTWARE#
Note: If the active management module and the standby management module are running on different operating systems because the boot set-default command was executed and then the standby module was rebooted, the write memory command displays this warning: "Warning: The next reboot or failover is set to boot from a different software image. The saved configuration file is sync’d to the standby management module.
The saved configuration becomes the boot-up configuration of the switch the next time it is booted. When using redundant management, saves the running configuration of the switch to flash on the active management module. The saved configuration becomes the boot-up configuration of the switch on the next boot. Saves the running configuration file to the startup-config.
0 kommentar(er)
